REF: K3SY-100

K3 Synthetic Cannabinoid Detection Test Instructions

Principles of Identification Test

This test is a rapid immunological device for the detection and identification of presumptive drugs or their cutting products (PINACA, BINACA, BUTINACA, FUBINACA, etc).

Depending on the sample and the substance sought, it can meet different needs:

  • Detect synthetic compounds in the flower sample.
  • Identify any synthetic compounds in alternative substances like hash, resin, etc.

This test is intended for laboratories, law enforcement agencies, associations working to reduce the risks associated with drug use, as well as anyone seeking to identify an unknown, suspicious or possibly harmful substance.

More information on cannabinoids.
Includes swab, rapid test, and dilution liquid.

指示

Follow instructions carefully to ensure accurate results and prevent common issues. Read all warnings and notices that are presented and exercise caution where necessary.

  • Step 1

    Check that all the dilution liquid is at the bottom of the sampling vial (plastic with green cap) by tapping it 2-3 times against a hard surface.

  • Step 1

    Prepare 50mg (approximately the size of a small pea) of the sample.

  • Step 2

    Unscrew and remove the large green cap from the vial and insert the sample into the solution inside.

  • Step 2

    Using the handle of the sampling swab, press the sample firmly against the bottom and sides of the vial, then mix it vigorously with the dilution liquid until the liquid turns slightly the same color (usually green) as the sample.

  • Step 2

    Screw the large cap back on tightly and shake the vial vigorously for 10 seconds to homogenize (combine) the mixture thoroughly.

  • Step 2

    Remove the test case from its packaging and place it on a flat, clean and dry surface.

  • Step 2

    Unscrew the small transparent cap from the large green cap of the plastic vial and pour 3-4 drops of solution into the well of the test case until you start to see the strip absorb the liquid. Note: the first couple of drops might not go in due to surface tension, so add drop by drop as necessary until the test starts to absorb the liquid.

  • Step 2

    Wait 5 minutes before reading the result and compare the lines for the result.

Results interpretation

The result area has 2 lines: the control line “C” and the test line “T”.

Test Validity

If the C line is not displayed, then the test is invalid. The operation must be repeated with a new test.

Negative Test

If the T line is displayed, this means that the substance sought has not been detected. Attention: any line visible, even faintly, must be considered as present.

Positive Test

If the T line is not displayed (TOTALLY absent), this means that the substance sought has indeed been detected.

Compare Results

Result

Display

Positive: contains traces found in sample.
Fentanyl test strip result showing one C line indicating positive result
Negative: no traces found in sample tested.
Fentanyl test strip result showing two lines indicating negative
Inconclusive: test is not valid.
Fentanyl test strip result showing one T line and no lines indicating inconclusive result

Storage recommendations

  • Store these tests in their original packaging, below 35°C (95°F) and protected from direct sun light.
  • Do not open the pouch containing the test until ready to use.
  • Keep out of reach of children.
  • Avoid eye, mouth, nose or skin contact with the dilution liquid in the vial, which may cause irritation (first aid measure: rinse thoroughly with water). Wearing gloves is recommended.
  • Do not use after the expiration date.

Disclaimer

Regardless of the result obtained, extreme vigilance is required, as:

  • The sample may contain harmful or toxic substances not identified by the test.
  • It is possible that an error in procedure, handling, or the unexpected presence of interfering substances may cause an erroneous result.
  • A negative result does not guarantee the absence of the sought substance, as it may be present at a concentration level below the detection limit of the test.
  • This test cannot give any indication of the amount or proportion of a substance present in the sample being tested.
  • No rapid test can be 100% reliable. Therefore, the results obtained by this test must imperatively be confirmed by a reference analytical method such as GC/MS and HPLC-MS/MS.
  • This test is a professional device to assist in the detection and identification of presumptive drug samples or cutting products. It is not intended to test “anything and everything” (beverages/sodas/alcohols, food products, household products, phytosanitary products, cosmetics), which may contain chemical or biological compounds that could interfere with the proper functioning of the test.
  • This test is not designed to work on human skin, nor on biological fluids.

For these reasons, Happy Test cannot be held responsible for any damage or accident that may result from the use of this test.

WARNING: The possession and use of drugs is prohibited by law and we do not endorse or encourage the sale or consumption of any illegal activity.